Submit the paper online to : apmcipet2010@gmail.com

Selected research works will be published in International Journal of Plastics Technology (IJPT), published by M/s Springer.

Paper title: 14 PT BOLD, CAPITAL LETTERS; Authors’ names: 12 pt bold (presenting author name should be underlined); Affiliations: 10 pt italic; Abstract heading: 12 pt bold; Abstract text: 12 pt; Key words: 12 pt; Main headings: 12 PT BOLD, CAPITAL LETTERS and Subsidiary headings: 12 pt bold.

TITLE OF THE PAPER (14 pt, bold)

Author A¹ , Author B¹ , Author C² (12 pt, bold)

¹ Corresponding Institute
² Corresponding Institute

* E-mail of the Corresponding Author

ABSTRACT (12 pt)

An abstract not exceeding 100 words should appear on top of the first page under the chapter titled "Abstract" (without chapter number). The abstract is preceded by the title of the paper, the names of the authors and the contact information of the corresponding author (12 pt).

Key Words: 4-5 keywords (12 pt)

1. INTRODUCTION (12 pt, CAPITAL LETTERS, BOLD)

The guidelines relate to the full text submission for the “International Conference on Advancements in Polymeric Materials”. The paper must be written in English. All authors are expected to submit carefully written and proofread material. The maximum length for full papers is 4 pages.

The deadline for the full text submission is January 15, 2010.

2. PAPER FORMAT

The paper should be written in MS Word format. Use A4 format only (21 cm x 29.7 cm). Please use Times New Roman as font and single line spacing for the entire abstract. There should be a left margin of 1.5 cm and a bottom, top and right margin of 1.0 cm.  

The paper should be structured as follows: An introductory section including the main scope and aims of the investigation, material and experimental, results and discussion, conclusion and references.
Please insert page numbers in your paper

2.1 Fonts

Please use 12 pt for the main body of the text and a single space should be placed between the paragraphs. Use the following fonts for the other sections:

2.2 Section Headings and Numbering

Each new section and subsection should have a heading numbered properly. Provide appropriate subsections.

2.3 Tables and Figures

Tables and figures should be cited in the text and placed after their first reference. Please do not use colored photos and prints. They should be numbered and use Times New Roman, 10 pt for the headings and captions. Table headings should be centered above the tables and figure captions, centered below the figures.

Heading above table : Table 1. Heading of the table (centered)

FIGURE
Heading below figure : Figure 1. Caption of the figure (centered)

2.4 Equations and units

Equations should be placed on a separate line from the text with clear expressions. The equations should be numbered consecutively at the outer right margin.

E = m.c²                                                        (1)

Please use IS (International System of Units) system for the definition of the units.

3. REFERENCES

Reference numbers in the text should be placed between square brackets, e.g. [1]. The references should be listed in the same order as cited in the text. Please note that all references listed in the references section must be directly cited in the body of the text.

1. Author(s), Title of the paper, Name of the Journal (in italics), Vol. (Issue), 235, 2008
2. Author(s), Title of the Book (in italics), Publisher, Place of Publication, 235-242, 2008.
3. Author(s), Title of the conference paper, Book of Proceedings, Conference location, 2008, 235-242.